Carp Measuring and Marking Accessories - Millimetric Accuracy on the Bait Bed
ÎIn modern carp fishing, consistency is the key to success: to have consistent results, you need to place your bait and lure in exactly the same spot every time you cast. ÎIn this category you will find a full range of measuring and marking accessories, essential tools that allow you to map the lake bottom and memorize precise fishing distances.
ÎWe provide you with Distance Sticks equipped with calibrated cords, Marker Floats with increased visibility for locating thresholds, reflective tape and special ropes or elastics for marking knots on the line. Equip yourself with precision tools that completely eliminate the need to approach the water's edge.
Technical Guide & FAQ
How do you use distance sticks?
Distance sticks are driven into the ground at a fixed length (determined by the connector cord, usually 3 or 3.6 meters). Once you've found the hot spot with the marker rod, you clip the line into the reel clip, come to the sticks, and wrap the line in a figure-8 shape around them, counting the turns. Then, you put the rods you are fishing with on the stakes and deploy them at exactly the same number of turns to fish to the millimeter in the same place.
What is a Marker Float and how does it help you find the rapids?
The marker float is a large, aerodynamic float attached to a special mount with a sliding lead. Launched into the water, it allows you to measure the exact depth (by releasing line from the reel centimeter by centimeter until the float comes to the surface) and to feel the structure of the bottom. It is the ideal tool for identifying rapids, areas with fine gravel or holes where carp are looking for food.
Why use a marker elastic instead of leaving the line on the clip while fishing?
Leaving the line on the reel clip while fishing is dangerous, as a large carp can break the line when it reaches the end of the distance. The correct solution is to tie a marker knot with a special rubber elastic directly on the line, after you have established the distance. After casting, you catch the line in the clip using the knot as a reference, but after you have positioned the rod on the sensors, remove the line from the clip - the elastic will show you where to re-clip after you have fished.